Boil & Bite Mouth Guards Manufacturer

The fitting experience decides the reorder

Boil and bite is still how most of the world fits a mouth guard, and the two questions that decide whether it sells are how soft the material goes and whether the customer has to trim it. TPE moulds at 70 °C in about 40 seconds and needs no trimming; EVA needs 75 °C and a minute, but holds its shape longer in a hot car or a kit bag. We mould both on the same tools, so the choice is a material decision rather than a tooling one. Transparent versions use optical-grade EVA and a controlled cooling cycle to avoid the bubbles that make a clear guard look cloudy, which is a moulding problem rather than a material one.

Showing 3 styles · MOQ 100 pcs/style · sample in 5–7 days
TPE Boil & Bite Mouth Guard

Boil & Bite Mouth Guards

TPE Boil & Bite Mouth Guard

TPE instead of EVA: softer, more rubbery, and it moulds at a lower temperature, so it is the guard to specify if your market complains about hard plastic. It is also easier to fit without trimming, which cuts down on returns from customers who cut too much off the back.

Construction: Single layer, 3.5 mm Material: TPE (thermoplastic elastomer) Fit: Boil & bite, no trim needed Design: Soft TPE, pre-formed arch
Clear Boil & Bite Mouth Guard

Boil & Bite Mouth Guards

Clear Boil & Bite Mouth Guard

A fully transparent guard for players who do not want one seen, and for retailers who want a neutral SKU that sells across sports. Transparent EVA is harder to mould without bubbles, so the tooling and the cooling cycle matter more here than on a coloured shell.

Construction: Single layer, 3.0 mm Material: Transparent EVA Fit: Boil & bite Design: Fully transparent, invisible when worn
Thermoform Mouth Guard

Boil & Bite Mouth Guards

Thermoform Mouth Guard

A deeper-draw guard that covers the molars further back than a standard shell, for players with a wide arch or a history of jaw injury. Thermoforming lets the rear wall be thicker without stiffening the front, which is where a single-layer guard usually fails.

Construction: Dual layer, 4.5 mm Material: EVA, thermoformed laminate Fit: Boil & bite, deep draw Design: Deep molar draw, reinforced front

Do not see the guard you need?

We keep 260+ moulds on file and develop new shells in 5–7 days.

Send a reference